22
19. DATA PLATE
All All units are identified with the following data plate. In all communications with the manufacturer
please indicate the serial number.
20. SAFETY RECOMMENDATIONS
The start-up of the unit and its reparation must be carried out by qualified personnel.
To minimise the risk of accidents during the installation, start up or maintenance tasks, below
instructions must be followed.
It is mandatory to observe the recommendations and instructions as shown in manufacturer manuals,
plates and specific instructions. It is also mandatory to observe law and regulations.
Before operating on the unit, verify that the general supply is disconnected to avoid
electrical shocks.
Refrigerant leaks may cause:
§ Suffocation due to oxygen displacement in the atmosphere, narcotic effect or heart
arrhythmia.
Ensure that the working area is properly ventilated.
§ Eye irritations or burns may be caused if refrigerant comes into contact with the skin.
Use a safety mask and a pair of gloves. Avoid any contact between the refrigerant and
the skin and mind any sharp end of the unit.
To Next Page
Loading...