Integra CDC-3.1 User Manual

13
RANDOM
REMOTE CONTROLLER RC-435C
REPEAT
REMOTE CONTROLLER RC-435C
Random
Repeat
Random
123
456
RANDOM DISC No.
TRACK
SINGLE ELAPSED
123
456
RANDOM DISC No.
TRACK SINGLE ELAPSED
Repeat
Play
123
456
DISC No.
TRACK
REPEAT
NEXT
TOTAL REMAIN
123
456
DISC No.
TRACK
SINGLE ELAPSED
REPEAT
Playing CDs
Playing back tracks at random
Press the Random button on the unit or the remote
controller to enter random mode.
The CD changer will play all tracks on all six discs at
random.
• To cancel random play, press the Stop or Ran-
dom button.
• The unit stops when it completes playback of all
tracks on all discs.
If you have pressed the Repeat button, the unit will
repeat playback of all tracks at random after it fin-
ishes playing all tracks once.
• During random playback, the Disc 1 - Disc 6 but-
tons, the Disc Skip button, and the number but-
tons will be disabled.
• Discs can be exchanged during random play-
back. However, if you add a disc with a different
number of tracks, all tracks will be played back.
A disc that contains the same number of tracks
will not play back track numbers that have al-
ready been played. If a disc for which all tracks
have been played is exchanged, the new disc is
not played.
• Random mode can be operated together with
memory mode and repeat mode. However, if the
whole disc is stored into memory and the disc is
selected, no other songs are played until the ran-
dom playback of tracks from this disc is com-
pleted. (Refer to “Using Memory Functions” on
page 14 for more information on memory play-
back.)
Repeating all tracks of all discs
1. Press the Repeat button on the unit or the remote
controller to enter the repeat mode.
The REPEAT indicator will light up.
2. Press the Play button.
All tracks from all discs inserted in the disc trays
will be played back repeatedly.
Repeat playback can be used with normal, ran-
dom, and memory playback modes (see “Using
Memory Functions” on page 14). You can press
this button either before or during playback.
3. To cancel the repeat mode, press the Repeat
button.
The REPEAT indicator goes off.
CDC-3.1_08-13 09/05/2000, 4:24 PM13

Integra CDC-3.1 Specifications

Audio Output

number of channels	2 (stereo)
frequency response	5 Hz - 20 kHz
total harmonic distortion	0.005% (at 1 kHz)

Power

power consumption	10 watts
power supply	120 V, 60 Hz
output level	2 volts r.m.s.

Performance

dynamic range	96 dB
signal to noise ratio	92 dB
channel separation	92 dB (at 1 kHz)

Optical System

signal readout system	Optical non-contact
reading rotation	About 500 - 200 r.p.m.
linear velocity	1.2 - 1.4 m/s

Weight and Dimensions

dimensions	435× 131× 433mm
weight	6.9 kg