Integra CDC-3.1 User Manual

12
1
2
3
Disc 1 Disc 2 Disc 3 Disc 4 Disc 5 Disc 6
NEXT SELECTION
REMOTE CONTROLLER RC-435C
Next Selection
123
+10 0
456
789
REMOTE CONTROLLER RC-435C
123
456
NEXT DISC No.
TRACK
123
456
NEXT DISC No.
TRACK
//
Next Selection
3
1
2
Playing CDs
Selecting the next track to play back
This function enables you to select the next track or
disc to play back.
1. Press the Next Selection button during playback.
2. Select the disc you wish to play using the Direct
Play buttons (Disc 1-6).
• You can also use the Disc Skip button to select a disc.
• When you wish to play the entire disc, press the
Next Selection button at this point. (AL means all
tracks)
• If you do not select a disc within approximately
eight seconds, your disc selection will be can-
celled. In this case, try Steps 1 and 2 again.
3. Select the track number you wish to play using
the
/ and / buttons and then press
the Next Selection button.
When the playback of the current track is com-
plete, the selected track will play.
You can use the number buttons on the remote
controller to select a track number. In this case, you
do not need to press the Next Selection button.
• If you select an entire disc to play back, the unit
will first complete playback of the current disc,
then play back the selected disc. If you select a
track to play back, the unit will first complete play-
back of the current track, then play back the
selected track.
• You can use the Next Selection function during
memory playback, random playback, and
memory random playback (see “Using Memory
Functions” on page 14, and “Playing back tracks
at random” on page 13). In these cases, the unit
will first complete playback of the current track,
then start playing back the selected disc or track,
and the memory playback, random playback,
or memory random playback will be cancelled.
Notes:
• If after making your selection, you use the Disc
Skip button,
/ and / buttons, or the
number buttons to change the track for play-
back, the settings will be cancelled.
• The Next Selection function is effective only once
at a time. The function will be cancelled when the
selected disc or track starts playing back after
playback of the current disc or track is completed.
• If you press the Stop button, the setting will be
cancelled.
To select another disc or track ...
Press the Next Selection button. The currently-se-
lected disc or track number will flash on the panel.
You can change this number in the usual way.
To cancel the selection ...
Press the Next Selection button. The selected disc
or track number will flash on the panel. Press the
Clear button, and the selected disc or track will be
cancelled. Press the Next Selection button.
• The NEXT indicator will turn off.
CDC-3.1_08-13 09/05/2000, 4:24 PM12

Integra CDC-3.1 Specifications

Audio Output

number of channels	2 (stereo)
frequency response	5 Hz - 20 kHz
total harmonic distortion	0.005% (at 1 kHz)

Power

power consumption	10 watts
power supply	120 V, 60 Hz
output level	2 volts r.m.s.

Performance

dynamic range	96 dB
signal to noise ratio	92 dB
channel separation	92 dB (at 1 kHz)

Optical System

signal readout system	Optical non-contact
reading rotation	About 500 - 200 r.p.m.
linear velocity	1.2 - 1.4 m/s

Weight and Dimensions

dimensions	435× 131× 433mm
weight	6.9 kg