23
> Network Functions > Specifications > Advanced Setup > Listening Modes
Troubleshooting Supplementary Information, etc�|
> Basic Manual
Setting Item Default Value Setting Details
Pairing
Information
- You can initialize the pairing information saved on
this unit.
Pressing Enter when "Clear" is displayed
initializes the pairing information stored in this unit.
•
This function does not initialize the pairing
information on the BLUETOOTH wireless
technology enabled device. When pairing the
unit again with the device, be sure to clear
the pairing information on the BLUETOOTH
wireless technology enabled device in
advance. For information on how to clear the
pairing information, refer to the BLUETOOTH
wireless technology enabled device's
instruction manual.
Device - Displays the name of the BLUETOOTH wireless
technology enabled device connected to the unit.
•
The name is not displayed when "Status" is
"Ready" and "Pairing".
Status - Displays the status of the BLUETOOTH wireless
technology enabled device connected to the unit.
"Ready": Not paired
"Pairing": Paired
"Connected": Successfully connected
•
Wait for a while if "Bluetooth" cannot be selected. It will appear when the BLUETOOTH function is
started up.
■ 4� Power Management
Setting Item Default Value Setting Details
Sleep Timer Off Allows the unit to enter standby automatically when
the specified time elapses. Select a value from "30
minutes", "60 minutes", and "90 minutes".
"Off": Does not turn the unit to standby
automatically.
Auto Standby On/Off This setting places the unit on standby
automatically after 20 minutes of inactivity without
any video or audio input. (When "USB Power
Out at Standby" or "Network Standby" is on, this
becomes the Hybrid Standby mode which reduces
the increase in power consumption to a minimum.)
"On": The unit will automatically enter standby
mode ("AUTO STBY" will light).
"Off": The unit will not automatically enter standby
mode.
•
"Auto Standby" is displayed on the display and
TV screen 30 seconds before the Auto Standby
comes on.
•
"Auto Standby" does not work when Zone 2 is
active.
•
Default values vary depending on the regions.
Auto Standby in
HDMI Standby
Through
Off Enable or disable "Auto Standby" while "HDMI
Standby Through" is on.
"On": The setting will be enabled.
"Off": The setting will be disabled.
•
This setting cannot be set to "On" if "Auto
Standby" and "HDMI Standby Through" are set
to "Off".
USB Power Out
at Standby
Off Devices connected to the USB port are supplied
with electricity even when this unit is in standby
mode when this function is "On".
•
When using this feature, power consumption
increases even when the unit is on standby,
however, the increase in power consumption
is kept to a minimum by automatically entering
the Hybrid Standby mode, where only essential
circuits are operating.
To Next Page
Loading...
Need help?
General
