Integra DRX-3.4 - Page 136

136
SetupSetup
6. Hardware
 Output Zone (Default Value: Main)
Select the zone where you want to listen to the music.
• To use this function, set "Input Selector" beforehand.
Main Outputs audio only to the main room (where this unit is
located).
Zone 2 Outputs audio only to the separate room (Zone 2).
Main/Zone 2 Outputs audio to both the main room and separate room (Zone
2).
Zone 3 Outputs audio only to the separate room (Zone 3).
Main/Zone 3 Outputs audio to both the main room and separate room (Zone
3).
Zone 2/Zone 3 Outputs audio to both the separate rooms (Zone 2 and Zone
3).
Main/Zone 2/
Zone 3
Outputs audio to the main room and both separate rooms
(Zone 2 and Zone 3).
 Preset Volume (Default Value: Main=Last / Zone 2=Last / Zone
3=Last)
You can set the volume beforehand for playing back the Sonos Connect. You
can set volumes for the main room (where this unit is located) and separate
room (Zone 2 or Zone 3) respectively. Select a value from "Last" (Volume level
before entering standby mode), "Min", "0.5" to "99.5" and "Max".
• To use this function, set "Input Selector" beforehand.