Controls, Indicators and operation
- 4 -
16. ANL/PA key
ANL (Automatic Noise Limiter) FUNCTION
Shortly press the ANL/PA (16) key to enable the ANL (Automatic Noise Limiter) function, in order to reduce
electric or electromagnetic noise or interference on the used channel. The LED indicator (5) is lighted to
confirm that the ANL function is enabled. Press again the ANL /PA(16) key to disable the function.
PA (Public Address) CONTROL
The radio includes the PA (Public Address) function, in order to spread audio messages through an external speaker. To
use the PA function, connect an external speaker (optional) to the PA jack (19) located on the rear side of the radio.
Press the ANL/PA (16) key for about 1.5 seconds. The LED display (7) wil show PA. Now it is possible to press the PTT
(22) key and speak into the microphone to spread your message through the external speaker.
17. MICROPHONE Connector
Connect the supplied condenser microphone to this connector, locking it through the ring nut.
English
Rear Panel
18. ANTENNA Connector
Antenna connector. Refer to the section INSTALLATION OF THE ANTENNA.
19. PA Jack
If the PA function has to be used, connect to the external speaker (optional) to this jack. Refer to item no. 16.
20. EXT (External Speaker) Jack
This jack is for connecting an external speaker (optional).
21. 13.2VDC POWER CORD
13.2VDC power cord input.
To Next Page
Loading...
