Setup BIOS provides function, for example virus, boot-strap induct
¾ Advanced Chipset Features
Setup main board chipset parameter’ for example DRAM Timing
¾ Integrated Peripherals
Setup include main board all peripherals drive
¾ Power Management Setup
Setup CPU, Hard disk, Monitor drive power save mode
¾ PnP/PCI Configurations
Setup PnP and PCI interface parameter
¾ PC Health Status
Setup CPU/System temperature and FANs/Voltage Measurements
¾ Frequency/Voltage Control
Setup CPU frequency/Voltage in system
¾ Load Fail-Safe Defaults
Setup the best performance values in system
¾ Set Supervisor Password
Setup supervisor password in system
¾ Set User Password
Setup user password in system
¾ Save & Exit Setup
Setup save and exit, press Y to save and exit
¾ Exit Without Save Setup
Setup without save and exit, press N to without save and exit
6.2 Standard CMOS Features
¾ Date (mm:dd:yyyy)
These items set up system date
¾ Time (hh:mm:ss)
These items set up system time
¾ Pri/Sec Master/Slave
These items configure device connected to the Primary and Secondary IDE
channels. To configure an IDE hard disk drive, choose Auto. If the Auto setting
fails to find a hard disk drive, set it to User, and then fill in the hard disk
characteristics manually. If you have a CD-ROM drive, select the setting CD-
ROM. If you have an ATAPI device with removable media, select Fl optical.
6.3 Advanced BIOS Features
¾ CPU L1&L2 Cache
Leave these items enabled since all the processors that can be installed on this
board have internal L2 cache memory.
¾ First Boot Device
When system boot-strap first time detect device.
¾ Second/Third Boot Device
When system boot-strap first time detect device.
To Next Page
Loading...
Need help?
General
