Intel D845PEBT2 Quick Reference

Intel Desktop Board D845PEBT2 Quick Reference 17
For a complete list of BIOS Setup settings, see:
• The Intel Desktop Board D845PEBT2 Product Guide on the Intel Express
Installer CD-ROM
• The Intel World Wide Web Site at
http://support.intel.com/support/motherboards/desktop/
Troubleshooting
Desktop Board D845PEBT2 system fails to boot
• Ensure that the power supply cable with the 4-pin connector is plugged into
the 12 V processor core voltage connector located near the processor socket
on the desktop board.
• Remove and re-insert the Intel Pentium 4 processor, memory, and any
add-in cards to make sure they are fully seated. Remove any non-essential
hardware components and boot the system.
• Disconnect all power and remove the CMOS battery. Wait 10 minutes,
then re-install the battery, reconnect power, and boot the system.
A repeating beep error code is heard and the desktop board does not boot
or show any video
This beep code may indicate a problem during detection of the DDR SDRAM
memory device. Check to ensure that system memory is properly installed and
that the DIMMs meet the Memory Module Requirements listed in the Supported
Components section of this document.
Resolving slow boot times
Extended boot time can be the result of IDE drive jumper configuration. For
additional information visit:
http://support.intel.com/support/motherboards/desktop/slowboot.htm
Only 1.5 V AGP 2X/4X graphics cards are supported
The AGP connector on this desktop board is keyed for 1.5 V AGP cards only.
The AGP connector is not mechanically compatible with 3.3 V AGP cards. To
some, the 1.5 V AGP connector may appear backwards because the connector
key is exactly the opposite of the 3.3 V AGP connector.

Intel D845PEBT2 Specifications

General

Brand	Intel
Model	D845PEBT2
Category	Motherboard
Language	English