Intel Desktop Board DH61BE Technical Product Specification
52
2.3 BIOS Configuration Jumper Block
CAUTION
Do not move the jumper with the power on. Always turn off the power and unplug the
power cord from the computer before changing a jumper setting. Otherwise, the board
could be damaged.
Figure 13 shows the location of the jumper block. The 3-pin jumper block determines
the BIOS Setup program’s mode. Table 27 describes the jumper settings for the three
modes: normal, configure, and recovery.
Figure 13. Location of the Jumper Block
To Next Page
Loading...
