Intel NUC 7 ENTHUSIAST User Manual

User Guide for NUC7i5BNKP, NUC7i7BNKQ
4
Upgrade System Memory
The Intel NUC Mini PCs NUC7i5BNKP and NUC7i7BNKQ have two 260-pin DDR4 SO-DIMM sockets,
that include pre-installed memory.
Pre-installed memory
NUC7i5BNKP
Two 4GB memory modules
NUC7i7BNKQ
Two 8GB memory modules
To upgrade memory, be sure to select memory modules that meet these requirements:
 1.2V low voltage memory
 2133 MHz SO-DIMMs
 Non-ECC
Find compatible memory modules in the Intel Product Compatibility Tool:
 NUC7i5BNKP
 NUC7i7BNKQ
To upgrade or add memory, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and
disconnect the power cord.
3. Remove the computer’s bottom chassis cover.
Upgrade to different memory
a. Remove the pre-installed memory module
i. Gently spread the retaining clips at each end of the memory socket, which causes
the module to pop out of the socket (C).
ii. Holding the module by the edges, lift it away from the socket, and store it
in an anti-static package.
b. Install the new memory module
i. Align the space at the bottom edge of the memory module with the key in
the socket.
ii. Insert the bottom edge of the module at a 45 degree angle into the socket
(A).
iii. When the module is inserted, push down on the outer edges of the
module until the retaining clips snap into place (B). Make sure the clips
are firmly in place (C).

Intel NUC 7 ENTHUSIAST Specifications

General

Brand	Intel
Model	NUC 7 ENTHUSIAST
Category	Desktop
Language	English