INSTALLATIONS
8
MB893 User’s Manual
Setting the Jumpers
Jumpers are used on MB893 to select various settings and features
according to your needs and applications. Contact your supplier if you
have doubts about the best configuration for your needs. The following
lists the connectors on MB893 and their respective functions.
Jumper Locations on MB893..........................................................9
JP2: Compact Flash Master/Slave Select......................................10
JP3: Clear CMOS Contents ..........................................................10
JP4: CN7 & CN10 LAN By-pass Function Setting...................... 10
JP5: COM2 (J6) Tx/Rx Signal Setting (Reserved).......................10
JP6: Case Open Connector (Reserved).........................................11
JP7: IDE1, IDE2 UDMA Cable Detect Setting............................11
To Next Page
Loading...
