INSTALLATIONS
10
MB893 User’s Manual
JP2: Compact Flash Master/Slave Select
JP2 Setting Compact Flash
Open Slave
Closed Master
JP3: Clear CMOS Contents
JP3 Setting Function
Pin 1-2
Short/Closed
Normal
Pin 2-3
Short/Closed
Clear CMOS
JP4: CN7 & CN10 LAN By-pass Function Setting
[
JP4 Setting Function
Pin 1-2&3-4
OPEN
System will bypass
LANs upon the
timeout of watchdo
timer
Pin 1-2&3-4
Short/Closed
(Default)
System will
reboot upon the
timeout of
watchdog timer.
JP5: COM2 (J6) Tx/Rx Signal Setting (Reserved)
JP5 Setting COM2 (J6)
Pin 1-3&2-4
Short/Closed
TTL
Pin 3-5&4-6
Short/Closed
(Default)
RS232
Important Note: Should the two jumper clips or the jumper itself (JP5) be
missing, this means that the default setting is fixed as RS232.
To Next Page
Loading...
