15
Installing the Software in Linux
To install the software in RedHat* Linux Version 7.2 using the RPM
utility, follow these steps:
1. Locate the RPM package is1000-1.1-#.i386.rpm (# represents the
RPM version number) for a single or multiple processor host.
2. Install the package:
# rpm -i [...]/RedHat72/is1000-1.1-#.i386.rpm (# represents the
RPM version number)
NOTE: The installation process will install support for a single and
multiple processor systems, but at boot-up, the SYS V script will
determine which kernel is booting and load the appropriate
module.
Configuring the Software
The Intel
®
PRO/1000 T IP Storage Adapter software can be used in a
Windows* (2000 or XP) or RedHat* Linux environment.
NOTE: If you already have one adapter installed and configured in your
system and you would like to install another adapter, remove all
the targets in PROSet before installing the new adapter.
Otherwise, PROSet indicates that both adapters are connected to
the same target and multiple connections to the same target can
occur.
NOTE: The Intel PRO/1000 T IP Storage Adapter allows you to connect to
a maximum of eight iSCSI targets at a time.
Linux
RedHat* Linux Version 7.2 configuration information is located in the
Readme.txt file in the RedHat72 directory on the Intel CD.
To Next Page
Loading...
Need help?
General