Intel Solid State Drive 750 Series - User Manual

Physical Installation Instructions for Intel®
Solid State Drive 750 Series
See the instructions below for how to install the Intel® Solid State Drive 750 Series hardware.
For compatibility with NVM Express* (NVMe*), use with a system based on an Intel® Z97
Chipset, Intel® X99 Chipset, or later chipset.
Before you begin
Caution
Disconnect the desktop board's power supply from its AC power source before you
connect or disconnect cables, or install or remove any board components.
Without first disconnecting the power supply, you risk personal injury or equipment
damage.
Some circuitry on the desktop board can operate even if the front panel power switch
is off.
Electrostatic discharge (ESD) can damage desktop board components. Install the board
at an ESD-controlled workstation. If an ESD-controlled workstation is unavailable,
wear an anti-static wrist strap or touch the surface of the anti-static package before
handling the board.
Prepare
Your board may have multiple PCIe* slots. The PCIe SSD needs a PCI Express* (PCIe) x4
connector. Best performance is with a PCIe 3.0 connector.

Summary

Before you begin

Caution

Warning about circuitry and ESD risk during installation.

Prepare

Requirements for PCIe slots and connector types for the SSD.

Installation steps for Intel SSD 750 Series Add-in Card (AIC)

Installation steps for the Intel SSD 750 Series 2.5-inch drive

Intel Solid State Drive 750 Series Specifications