Intelbras AMT 8000 - Page 153

153
» Programming the gateway
Enter + 8140 + Enter
After the command, enter the network gateway number and press the Enter key
to conrm.
» Programming DNS Servers for Ethernet
Enter + 815 + S + Enter , where S = 1 or 2 (Server 1 or Server 2)
After the command, enter the DNS1 server number and press the Enter key to
conrm.
» Program the Heartbeat Ethernet interval (link test)
Enter + 816 + TTM + Enter , where TTM = time interval ranging from 000 to 255
minutes (factory minutes 5 minutes )
» IP address of the alarm center
Enter + 8120 + Enter
» Program login
Enter + 822 + O + Enter , where O = 1 or 2 (Operator 1 ou Operator 2)
After the command, type the login (according to the operator used) and then press
the Enter key to conrm.
» Enable chips
Enter + 832 + Enter
After the command, use the keys on the keyboard to enable options 1 (chip 1), 2
(chip 2).
» Program password
Enter + 823 + O + Enter , where O = 1 or 2 (Operator 1 ou Operator 2)
After the command, type the password (according to the operator used) and then
press the Enter key to conrm.
» Program APN
Enter + 824 + O + Enter , where O = 1 or 2 (Operator 1 ou Operator 2)
After the command, type the APN (according to the operator used) and then press
the Enter key to conrm.
» Programming the PIN (Personal Identication Number)
If you want to use the PIN, make the command in sequence, otherwise go to the
next command.