Intelbras AMT 8000 - Page 24

24
The following gure shows the illustrative image of the repeater:
Range RF Amplier (REP 8000 Repeater)
Range RF Amplier (REP 8000 Repeater) has a tamper key against violation,
located at the back of the repeater, and if this key is opened/violated, registered
sirens will trigger and send the corresponding event if the Problems that generate
trigger function is enabled (see the Problems that generate trigger section).
The installation of the Range RF Amplier (REP 8000 Repeater) can be on various
surfaces, always placing it in a vertical position with a height between 1.80 and
2.20 meters from the oor and using double-sided tape or screws (not included)
to x the base and after securing the device, tting and checking that it has
been placed correctly so that there are no falls and damage. The status of the
repeater communication with the alarm center will be represented on it through
the indicator LED located on the front, and when in normal communication the LED
will ash green, with partial communication orange and no communication red
(the indicator LED after 15 minutes will enter hibernation mode for battery saving,
not hindering the device communication and to activate again press the device
synchronisation key once).