30
This connection is necessary so that in case of reporting events or remote accesses,
the alarm center is not without communication or has it interrupted if other phones
of the same circuit enter/are in operation. In this case, when reporting events or
remote access, the other phones will be inoperative, because the center will be
occupying the line.
4.5. AMT 8000 Alarm Center
AMT 8000 alarm center has a tamper key against violation, and if this tamper
switch is opened/violated, registered sirens will trigger and send the corresponding
event if the
Problems that generate trigger
function is enabled (see section
Problems that generate trigger
).
Ethernet cables, AC power and telephone line should be directed through the hole
located at the rear of the alarm center.
Alarm center can be installed on several surfaces, always placing it in a vertical
position with a height between 1.80 and 2.20 meters and using double-sided
tape or screws (not included) to x the base and after securing the alarm center,
tting and checking that it has been placed correctly so that there are no falls and
damage, and directing the wires in the dedicated areas.
5. Operation
Once the installation is nished, connect the alarm center to the local mains and
the rechargeable battery.
Note:
to connect the AMT 8000 alarm center it is necessary that it is connected to
the AC mains and the 5-way cable of the source is wired to the
Source
connector
of the alarm center board, otherwise the alarm center will not power on even if the
same is with battery. With the alarm center on and the battery connected, it will be
recharged by the source and when the AC network is dropped the alarm center will
be maintained by battery power.
5.1. Description of the XAT 8000 LCD keyboard indications
The following icons are located on top of the LCD display:
» : If this icon is ashing, it indicates that a trouble has been detected.
» : it will light up whenever there is a shot in the siren
.
» P: with the icon lit, the center is in programming mode.
» Battery: indicates the battery status of the alarm center.
To Next Page
Loading...
