Intelbras AMT 8000 - Page 33

33
» Partial (stay): zones selected for this option remain inactive during activation in
Partial mode independent of the partition associated with it.
Example: Assuming that for partition 01, composed of zones 01 to 10, only
zones 01 to 05 are enabled as Partial mode. When the command for the
Partial mode option is executed for a specic partition, in this case, partition
01, if someone passes the sector where sensors 01 to 05 are located, the
alarm center will not re - zones where the occupants will be present and
during activation of the Partial mode they will not re, if someone passes the
sensors 06 to 10, the alarm center will re for partition 01, indicating such
sectors red, being signaled by sirens and sending events for monitoring/
applications, if used.
Note: during the complete activation of the partition - outside the Partial
mode (stay), all zones of the partition will trip.
5.5. Activation/deactivation of the alarm center
Alarm center can be activated and/or deactivated in different ways, depending on
the settings dened. For any of the ways of activating the system, with the output
time different from zero, after entering the password, the keyboard will beep at
intervals of 1 second. In the last ve seconds of the timer, these beeps will become
faster to indicate that the output time is at the end. Once the output time is over,
the siren will beep (if programmed) indicating that the alarm center is activated.
Attention: » For some programs of the alarm center and also to activate it, it is
necessary to use the 4-digit master password, indicated on the QR code
label inside the unit. This password can be changed as treated in the
following elds.
» If the center's system is reset, it will no longer use the random passwords
that are linked together with the QR code label pasted inside the alarm
center and will use the 1234 password as the master password and the
878787 password as remote access until they are changed again.
Note: » If there is an error when typing the password, press the Back key and type
the password again.