37
Bypass
Through this function it is possible to temporarily cancel one or more zones.
This function activates the zones that are cancelled (bypassed) during the next
activation will not generate triggers in the system if they are violated.
After the system is deactivated, the zones that were cancelled will return to normal
conguration. Only the master password user and users with bypass permission
can temporarily cancel a zone.
This function must be programmed no more than 30 seconds before the system is
activated, otherwise the operation will be withdrawn.
Procedure for temporarily cancel a zone is as follows:
1. With the system deactivated and out of programming mode, press the
Menu
key;
2. With the marker in the bypass position, press the
Enter key;
3. Using the numeric and directional keys on the keyboard, select which zones will
have the deletion (bypass) active (01 to 64);
4. Press the
Enter
key to conrm the deletion of the selected zones;
5. Enter the master password or a password with permission to cancel zones;
6. If an invalid password is entered, the
Incorrect password error
message will be
displayed and the keyboard will continue to display the zones to be overridden
until a valid password is entered or the 30 second time limit is exceeded. If a
password is entered without undo permission, the
No undo sensor
message will
be displayed and the operation will be cancelled immediately;
7. To cancel the operation, press the
Exit
key before entering the password.
To cancel a zone for more than 30 seconds before activation, enter programming
mode (
Enter + Password
) using a password with bypass permission and perform
steps 1 through 4. The next time the system is activated, the bypass will run even if
the user who activated the system does not have bypass permission.
Open Sensors
In normal operation mode, the XAT 8000 keyboard will display the status of the
alarm center and whether there are any open zones.
To view the currently open zones, press the
Menu
key and then access
Open Sens.
and press the
Enter key.
Outside the programming mode, if
1 + Enter,
is pressed, zones 1 to 10 will be
displayed. 2 + Enter displays the zones from 11 to 20, and so on, up to 7 key, which
displays the zones from 61 to 64.
To Next Page
Loading...
