41
Addr. MAC
It will display the MAC address of the alarm center. MAC address will display
with 12 digits between numbers and letters. Through this address the center will
connect to
online
servers.
Center version
It will display the alarm center version.
Keyboard version
It will display the version of the keyboard used.
Test
mode
It will perform the wireless signal test of the keyboard used with the registered
center. When pressing
Menu
, with the arrow keys leave the marker in
Test
mode
and press
Enter
.
The test will start, showing the
Signal test
information and at the end the
result, which can be
Excellent, Good, Weak
or
No response
in case of loss of
communication with the alarm center.
Note:
the signal level that appears on the keyboard for each of the devices refers
to the last communication it made.
Battery tens.
It will display the battery level of the keyboard.
5.7. Remote update
AMT 8000 alarm center has remote software updates, and if new software versions
are available, it is not necessary to use recorders or connect to computers to be
updated by downloading the new version through Ethernet or Wi-Fi connections.
When the version update is performed, the registration of the wireless devices or
saved settings will not be lost.
Attention: the software version update of the alarm center is a programming
and it is recommended that it is done by a qualied professional, with access
to the programming mode of the AMT 8000 alarm center (necessary commands
contained in the
6. Programming
item).
To Next Page
Loading...
