42
6. Programming
Alarm center has several programmable parameters, which makes it versatile,
allowing it to optimize the operation for each need.
These settings are stored in EEPROM type memory, thus avoiding the need for
frequent reprogramming or if it is not fed.
To program these parameters, it is necessary to use two special passwords, called
master password (the center initially has the random master password indicated
on the QR code label inside the cabinet) and installer password (factory default:
9090
). We recommend that they be modied during the installation to increase
system security, as this will prevent unauthorized persons from changing the alarm
center settings (see
6.8. Passwords section).
6.1. Programming mode
Using the XAT 8000 Wireless Keyboard
When accessing the programming mode, editing or viewing some programming on
the keyboard, if the sequence or password is accepted, 2 conrmation beeps will
be emitted, otherwise a long error beep will be emitted, in which case the insertion
of the password or command must be started again.
Enter programming mode
When you press the
Enter
key on the initial screen, the
Prog. Password
message
will be displayed, indicating that the center is waiting for the master password or
the installer password to be entered.
Entering the programming mode with the installer password
Installer password
+
Enter
Entering the programming mode with the master password
Master password
+
Enter
After entering the password, the
P
icon on the display will light up, indicating that
the alarm center is in programming mode.
To Next Page
Loading...
