46
Using the AMT 8000 programmer (for computers)
Using the software installed on a computer (Windows
®
system) it is possible to
access the programming menu of the center, provided that the password used
for access is registered. It is necessary that the center is connected to the Internet
(to use external network or via cloud) via Ethernet, Wi-Fi or GPRS connection
(necessary XAG 8000 module added to the alarm center).
Note:
it is required that the computer/remote access password is enabled, see
6.8.
Passwords
section.
Using Intelbras Guardian application (for mobile devices)
Through the application installed on a mobile device (smartphone/tablet –
Android
®
/iOS) you can access the alarm center to activate and deactivate it,
check sensor/zone status, send emergencies, among other functions. Through
the application will also receive current events from the alarm center, such as
activations, triggers and other occurrences. For access, the master password or
some secondary password must be placed, and the permissions in the application
will be the same as the password dened in the other accesses. The device must
be connected to the Internet via Ethernet, Wi-Fi or GPRS (XAG 8000 module added
to the device is required).
6.2. Wireless devices (register/delete)
AMT 8000 alarm center already comes with the wireless receiver integrated to it
in order to receive and transmit signal to sensors, keyboards and other devices.
Table below shows how many and which wireless devices can be registered in the
alarm center.
Types of devices Maximum devices Addresses
Keyboards XAT 8000 16 01 to 16
Controls XAC 8000 98 00 to 97
Sensors
XAS 8000
64 01 to 64IVP 8000 Pet
TX 8000
Sensor with photochecking IVP 8000 Pet Cam 8 01 to 64
Sirens XSS 8000 16 01 to 16
Range RF Amplier REP 8000 4 01 to 07
To Next Page
Loading...
