Intelbras AMT 8000 - Page 47

47
To facilitate the registration of the devices, it is recommended that before their
physical installation, the following steps be checked:
» Check that all devices are correctly installed with the battery.
» Leave the wireless devices near the alarm center to perform the correct registration
and check the correct addressing.
» First register the keyboards to allow them to be used to register the other devices
via programming.
» It is recommended to use a maximum of 8 sensors with photochecking IVP 8000
Pet Cam per AMT 8000 alarm center, however their registration can occur during
the entire address range exclusive to sensors (01 to 64).
Wireless devices mentioned can be registered in two ways, the rst using the alarm
center synchronization key and the other by programming mode using the XAT
8000 keyboard, as described below.
Wireless device registration by means of the alarm center synchro-
nization button
Synchronization of devices using the synchronization button is the simplest method
to add devices to the alarm center, however, in this method it is not possible to
select the position that the device will occupy in memory. Each new device will
occupy the rst free position. To register a device in a specic position use the
commands described in Register by keyboard commands section.
Press and release the synchronization button on the alarm center and wait for LED
3 located next to this button to be continuously lit, indicating that the center is
ready for wireless device registration.
When the registration of all devices is complete, press the synchronization button
of the alarm center again and check if LED 3 is back to the Pulsed mode (ashes
indicating its normal operation), indicating that the system has left the wireless
device registration mode.
Sensors, sirens and keyboards can be registered randomly, and each one will
assume the addressing order according to its type.
» Keyboards (addresses 01 to 16): with the function active in the alarm center
press the synchronization button on the keyboard, located at the back of same
(remove the support for xing on surfaces). The keyboard addressing will be
according to the sequence performed, respecting the maximum limit of 16 devices
of this type and after registration all of them, the common partition being added.
To change the keyboards partition, see Keyboards partition section.