48
To delete a registered keyboard in the alarm center, keep the synchronization
key of the device pressed for 20 seconds, until the
Unlocked keyboard
information is shown on its display.
Note: when physically erasing the keyboards, they must be erased from the
memory of the alarm center via programming. Otherwise, a wireless device
supervision failure will be generated.
» Remote controls (addresses 00 to 97): the control register follows the principle
similar to keyboards, however any of the control keys can be used to perform the
register. Each registered control will be associated to the user according to the
registration sequence, being the rst registered control address 00 (Master user)
and the other controls assuming the addresses 01 to 97 (secondary users) that will
have the same permissions as the users of the passwords that as factory default
can activate and deactivate the complete system. The third key leaves the factory
disabled and if you need to change any control settings, see
6.4. Functions of
Remote Control Key.
To delete a control registered in the alarm center, press the keys in positions
1 and 2 (following vertical orientation) of the device for 10 seconds until the
LED ashes twice in red.
Note: when physically erasing controls, they must be erased from the
memory of the alarm center via programming.
» Wireless sensors (addresses 01 to 64): follows the same principle as the
other devices, however each sensor will be associated to a zone of the alarm
center according to the registration sequence, starting with sensor 01 (corresponds
to zone 01) up to sensor 64 (corresponds to zone 64). With the function active in
the alarm center, press the synchronization key on each sensor that you want to
synchronize according to its models:
» IVP 8000 Pet: remove the protective cover from the battery compartment,
press the synchronization key on it and check if the LED ashes green,
indicating the success of the registration, in case of any failure the LED ashes
red and the process must be repeated.
» IVP 8000 Pet Cam: remove the back cover and press the synchronization key
on it, check if the LED blinks green, indicating the success in the registration,
in case of any failure the LED blinks red and the process must be repeated.
» XAS 8000/TX 8000: press the synchronization key located on the back the
same, check that the LED located on the front of the sensor blinks green,
indicating success. If the LED blinks red there has been a failure and the process
must be repeated.
To Next Page
Loading...
