Intelbras AMT 8000 - Page 49

49
To delete a sensor registered in the alarm center, hold down the synchronization
key on the device for 20 seconds until the LED ashes red twice.
Note: when physically erasing sensors, they must be erased from the alarm
center memory via programming.
» Wireless sirens (addresses 01 to 16): follow the same principle as the other
devices, with the synchronization function active on the alarm center, press the
synchronization key on the back of the siren (remove the base for xing on
surfaces) and check if the LED ashes green, indicating success in the registration,
if the LED ashes red then process must be repeated. The addressing of the siren
will be according to the sequence performed, respecting the maximum limit of
16 devices of this type and after the registration all being added the common
partition. To change siren partition, see Siren Partition section.
To delete a registered siren at the alarm center, keep the device synchronisation
key pressed for 20 seconds until the LED ashes twice in red.
Note: when physically erasing sirens, they must be erased from the memory
of the alarm center via programming.
» Range RF Amplier (REP 8000 Repeater, addresses 01 to 04): follow the
same principle as the other devices, with the synchronization function active in the
alarm center, press the synchronization key on the back of the repeater (remove
the base for xing on surfaces and turn on its power supply, because for it to
initialize the source must be on) and check if the LED blinks green, indicating
the success in the registration, if the LED blinks red there was some fault and
the process must be repeated. The repeater addressing will be according to the
sequence performed, respecting the maximum limit of 04 devices of this type.
To delete a repeater registered in the alarm center, hold down the
synchronization key on the device for 10 seconds until the LED ashes twice
in red.
Note: when erasing the repeater physically it is necessary to erase it from the
memory of the alarm center via programming.
Registering by keyboard command
The registration of devices by keyboard commands directs them to the desired
addresses, following the maximum limit of devices by type.
It is necessary to register the rst keyboard through the alarm center key (see
Cadastro de dispositivo sem o pelo botão de sincronismo da central section).