Intelbras AMT 8000 - Page 54

54
Ex: sensor 01 communicating with the repeater 01:
Reset wireless devices
It will erase all registered wireless devices, including the keyboard used to
perform the command. If you wish to re-register any device after the reset, it
will be necessary to physically delete it by the synchronization key and only after
conrmation of its deletion, by LED indication, it will be possible to re-register it.
To delete all wireless devices, enter:
+
+
7 Deactive Enter
+
Enter
Note: if the Reset Lock is activated, it will not be possible to perform this function
(see Bloqueiossection).
Changing RF Channel
AMT 8000 alarm center has 4 RF communication channels, operating in the
frequencies from 915 to 928 MHz and it is possible to change the channel used, if
in the place where the system is located there are already other devices using this
same frequency and thus causing interference.
To program this function, type:
+
630
RF
Channel
+
Enter
+
Enter
08 to 11
To edit/view the programmed value, type:
+
630
+
Enter Enter
After changing the congured value, press the Enter key. If you only want to view
the setting, press the Exit key and no programming will be changed.
Attention: When changing the channel of the alarm center, all devices registered
there (except remote control) must have the synchronization key pressed to direct
the device to the new channel, otherwise, they will not communicate with the
alarm center.