Intelbras AMT 8000 - Page 56

56
» Sensitivity: will adjust so that the sensor detects correctly, according to the
installation area, having the adjustment of 4 types of sensitivity, varying from
the minimum, normal, intermediate and maximum (factory standard normal
sensitivity ). Although programming is permitted at the center, it is not possible to
change the sensitivity of the XAS 8000 and TX 8000 sensors.
» LED: will set whether the LED of sensor transmission/detection will light up or
remain off when any movement is detected (factory default off , only lighting for
the rst 15 minutes after battery insertion).
» Operation mode: it will dene how the sensor will detect the movements, in
case of operation in Economy mode the sensor detects and once the sensor has
red, it is necessary to wait a time of two minutes without movement for it to
detect again. When in Continuous mode the sensor detects continuously, as
in wired sensors, that is, the sensor will trip every time it identies movement,
without waiting any time (Economy factor). Although programming is permitted
at the center, it is not possible to change the operating mode of the XAS 8000
and TX 8000 sensors.
To program these sensor functions, enter:
+
66 Zone
+
Enter
+
Sensitivity
01 to 64
+
LED
+
Mode of operation
0 = Sens. Minimum
1 = Sens. Normal
2 = Sens. Intermediate
3 = Sens. Maximum
0 = Off
1 = On
+
Enter
0 = Economic
1 = Continuous
To edit/view the programmed value, type:
+
Enter
+
66
+
Enter Zone
After changing the congured value, press the Enter key. If you only want to view
the setting, press the Exit key and no programming will be changed.
For the Sensitivity Programming, LED and sensor operation to be effective, it is
necessary to trigger the sensor tamper, a trigger or a fast activation of the sensor
synchronism button.