Intelbras AMT 8000 - Page 60

60
Note: » All keyboards leave the factory programmed for the common partition 00.
» Even if the keyboard is set to the partition, specic passwords are required to
perform the partition functions through it.
» A keyboard can be registered in a single partition or become common to all
partitions, and if the command is redone, only the last command will be valid.
Editing XAT 8000 keyboard messages
Through this function it is possible to customize the name of the zones, users and
wireless devices added to the alarm center. When an event occurs, the rst line of
the display will display predened messages indicating the event and the second
line will display the programmed name (up to 14 digits).
Predened messages are as follows:
Function Description
Activation Alarm center has been activated
Deactivation Alarm center has been deactivated
Trigger Trigger The second line will indicate which zone
24 Hour Trip Trip a zone 24 hours. The second line will indicate which zone
Panic Panic triggers. The second line will indicate which zone
Medical emergency Triggers for medical emergency. The second line will indicate which zone
Fire Triggers in a re zone. The second line indicates which zone
Tamper zone/sensor Tamper opening detected. The second line will indicate which zone
Low battery Wireless device with low battery
Wireless panic Remote control panic. The second line will indicate the user
Wireless Fire Remote-controlled re panic. The second line will indicate the user
Tamper devices Device violation. The second line will indicate the device
Change messages
To edit/view the programmed messages use the following table to support the
command:
+
Message group Active
+
Enter
+
User address,
device or zone
From 1 to 8
Table below
+
Enter
Table below