73
» Exit programming mode with the installer password or enter a new
command
Installer password (factory standard:
9090
).
Monitoring via Ethernet/Wi-Fi
The alarm center can report events via IP communication to monitoring companies
(Software Receptor IP Intelbras), for this the following commands must be
programmed:
If you are using the Wi-Fi connection before you set the monitoring options,
program the following commands:
Note:
the alarm center connects only with 2.4GHz routers.
» Entering the programming mode with the installer password
Enter + installer password
(factory default:
9090
)
» Insert name of Wi-Fi network to be connected
Enter + 850 + Enter + Insert network name + Enter
» Insert password of Wi-Fi network to be connected
Enter + 851 + Enter + Insert network password + Enter
» Enable Wi-Fi/dene type of network conguration to be connected
Enter + 852 + Enter + TP + Enter
» TP = type of conguration
Selection Type of conguration
0 Wi-Fi Disabled
1 Wi-Fi enabled / in case of AC failure, operates on battery
2 Wi-Fi enabled / only with active AC network
Note:
» After inserting each command and conrming with the
Enter
key, two
quick beeps must be heard, indicating that the programming was accepted,
otherwise, there was some error.
» The network name and password must be entered exactly as it was dened in
the router considering the upper and lower case letters. To change between
upper and lower case, press the
Disable
key.
» Schedule monitoring account
Enter + 15 + PP + Enter
, where PP = partition from 01 to 16
After the command, enter the 4-digit monitoring account number and press the
Enter
key to conrm.
To Next Page
Loading...
