Intelbras AMT 8000 - Page 72

72
6.9. Quick setup for SMS monitoring and programming
In this section the processes for reporting events for monitoring companies through
the phone line channels, IP communication and GPRS connection are briey
described. The option to send SMS is also described.
For more details on these programming please refer to the 6.16. Telephony and
Monitoring Settings section.
Monitoring via phone line
The alarm center can report events via phone line channel (DTMF) - necessary FXO
8000 module, for monitoring companies, for this the following commands must
be programmed:
Note: after inserting each command and conrming with the Enter key, two quick
beeps must be heard, indicating that the programming was accepted, otherwise,
there was some error.
» Entering the programming mode with the installer password
Enter + installer password (factory default: 9090 )
» Schedule monitoring account
Enter + 15 + PP + Enter , where PP = partition from 01 to 16.
After the command, enter the 4-digit monitoring account number and press the
Enter key to conrm.
» Program phone number for monitoring company
Enter + 10 + M + phone number of monitoring company + Enter , where M =
memory for 1 or 2 phone
» Program the reporting mode as Phone Adjust and Communication
Protocol for Phone 1 and 2 as Contact-ID
Enter + 17 + 1 + 0 + 0 + Enter
» Program the number of attempts to report an event in the factory default
- up to 9 attempts
Enter + 13 + T + Enter , where T = number of attempts from 1 to 9
» Program DTMF signal level
If the factory default DTMF level stored in the alarm center memory does not
work, type the following command and test all the options from 0 to 6 to see
which one gives the best result.
Enter + 18 + Enter + N + Enter, where N= level from 0 to 6