74
» Programming the reporting mode
Enter + 17 + 4 + 0 + 0 + Enter
» Program communication priority (Ethernet only)
Enter + 19 + 0 + Enter
» Program target IP
Enter + 801 + I + Enter
, where I = 1 or 2 (target IP 1 or target IP 2)
After the command, enter the IP number of the monitoring company (example:
192.168.001.100) and press the
Enter
key to conrm.
» Program IP network communication port
Port 1 =
Enter + 802 + 1 + Port number with 4 digits + Enter
Port 2 =
Enter + 802 + 2 + Port number with 4 digits + Enter
» Program target domain name (DNS)
If you don't want to use DNS, go to the next command, otherwise type:
Enter + 803 + D + Enter
, where D = 1 or 2 (DNS 1 or DNS 2)
After the command, type the DNS domain name and press the
Enter
key to
conrm.
» Program monitoring options via IP
Enter + 830 + Enter
After the command, using the keys on the keyboard, enable the desired option
from 1 to 4, where:
» 1: enables the sending of events to the monitoring company 1.
» 2: enables the sending of events to the monitoring company 2.
» 3: enables the domain name (DNS) of the monitoring company 1.
» 4: enables the domain name (DNS) of the monitoring company 2 and press the
Enter
key to conrm.
» Program DHCP
If you do not have a DHCP server or do not want to use this option, do not
enable it and perform the next steps, where netmask, gateway, etc., will be
added manually and not received from the connected network.
Enter + 831 + Enter
To Next Page
Loading...
