Intelbras AMT 8000 - Page 85

85
After entering the command, using the XAT 8000 keyboard, mark which partitions
the password will be allowed to, using the numbers on the keyboard to leave
marked for the partition. After changing the congured value, press the Enter key.
If you only want to view the setting, press the Back/Exit and no programming will
be changed.
Attention: besides the above mentioned programming points, user passwords
must be created/dened (topic Passwords ) besides registering wireless controls for
access (topic Remote controller ) and also dene partitioning of keyboards (topic
Keyboard ) and sirens (topic Wireless sirens ).
To edit/view the programmed value, type:
21
+
Enter
+
User number
+
Enter
From 01 to 96
6.12. Timings
Input Timing
The input timing is used when you want to have a time to enter the protected
environment and deactivate the unit without triggering the alarm (it is necessary
to enable the zone as timed, see Zone functions section ).
When it is activated, if any sensor connected to the timed zone is triggered,
the unit stores the violation and waits for the programmed time to trigger the
alarm. Therefore, if the unit is not deactivated during this period, the alarm will be
triggered even if the sensor has returned to normal.
This time is programmable from 000 (timing deactivated) to 255 seconds.
The timing leaves the factory programmed for 30 seconds (non-partitioned or
partitioned system applying to all partitions). On non-partitioned systems, program
the input time with the partition address being 01 .
Note: » The output beep on the keyboard exits the factory enabled mode and
will not beep for security measure on the keyboard when counting the input time.
» When the keyboard is closed and we activate the alarm center through the
application AMT MOBILE V3 or GUARDIAN, even with the Output Beep function
on the keyboard is enabled it will not emit the Beep.