86
To program this function, type:
+
42 Partition
+
Enter
+
Enter
01 to 16
000 to 255 seconds
+
Input time
To edit/view the programmed value, type:
+
42 Partition
+
Enter
+
Enter
01 to 16
After changing the congured value, press the
Enter
key. If you only want to view
the setting, press the
Exit
key and no programming will be changed.
Output Timing
Output timing is used when you want to activate the alarm center from the
keyboard, and have time to leave the site before the alarm triggers.
This time is programmable from 000 (timing deactivated) to 255 seconds and
leaves the factory programmed for 30 seconds.
If the timing is programmed, when the alarm center is activated by the keyboard,
it will beep every 1 second, and in the last 5 seconds of the timing, the beeps will
be faster.
All zones of the partition to be programmed will be affected by the output timing,
except for zones programmed as 24 hours, Panic, Medical Emergency or Fire.
The output timing is valid only for activation of the unit via keyboard. When
activation is done via remote control the timing will always be zero (instantaneous).
On non-partitioned systems, program the output time with the partition address
being
01
.
To Next Page
Loading...
