Intelbras AMT 8000 - Page 89

89
+
402 Weekday
+
Enter
Enter
From 1 to 7
1 = Sunday
7 = Saturday
+
To edit/view the programmed value, type:
402
+
Enter Enter
+
After changing the congured value, press the Enter key. If you only want to view
the setting, press the Exit key and no programming will be changed.
Time interval for date and time synchronization
When this function is enabled, the alarm center will synchronize the date and time
with the server where the Intelbras IP Receiver software is installed (24 hour factory
standard synchronization), for third party software they should be consulted. The
synchronization will occur in the following situations:
» At the programmed time interval.
» At the moment that the alarm center is connected to the mains.
» If the date and time are changed manually.
» If the connection to the server is down.
To program this function, type:
+
403 Time interval
+
Enter
Enter
From 000 to 255
hours
000 = disabled
+
To edit/view the programmed value, type:
403
+
Enter Enter
+
After changing the congured value, press the Enter key. If you only want to view
the setting, press the Exit key and no programming will be changed.