91
+
471
Time between tests
+
Enter
Enter
+
000 to 255 hours
Note:
To deactivate the periodic test by time interval, program as 000.
To edit/view the programmed value, type:
471
+
Enter Enter
+
After changing the congured value, press the
Enter
key. If you only want to view
the setting, press the
Exit
key and no programming will be changed.
6.15. Autoactivation
With this function enabled, the alarm center will activate if all zones are closed and
there is no movement in the environment during the programmed time, at any time
of the day, or after a programmed time. The time is programmable from 01 to 99
minutes (inactivity), that is, up to one hour and thirty nine minutes, at any time of
the day. In the case of partitioned centers, the
Autoactivation
when executed, will
be exercised on all partitions with the partition autoactivation option enabled. If
you want to use Partition Autoactivation, refer to
Program the Partitioning of the
Alarm Center
.
The following are examples of using autoactivation:
» Example 1
In a place where there is no xed time to activate the alarm center we can
program the
Autoactivation by inactivity
to occur whenever all sensors are
closed, for example, for 50 minutes. This time should be chosen according
to the site routine. If it is very busy, the time may be shorter. If there is little
movement of people, the time should be longer, to prevent the alarm center
from being activated in an unwanted hour.
» Example 2
In an ofce, which closes every day at 6:00 p.m., it can be programmed so
that the
Programmed Autoactivation
function only starts working from 6:00
p.m. onwards. In this way it is possible to reduce or eliminate the programmed
downtime, without risk of the alarm center being activated during the day.
To Next Page
Loading...
