92
Programmed and Inactivity Autoactivation can be used together. For example,
if you want the center to be automatically activated by inactivity only after
10:00pm.
For this programming we have 3 examples that explain the alarm center's
Autoactivation, displayed below, considering that the Programmed
Autoactivation will be at 10:00pm and the inactivity time will be 10 minutes:
1. A sensor (opening and closing) was detected at 9:50pm, so the center will
automatically activate at 10:00pm.
2. A sensor (opening and closing) was detected at 9:55pm, so the center will
automatically activate at 10:05pm.
3. One sensor (open only) was opened at 9:59pm and this sensor remained open
until 10:30pm, then the center will automatically activate at 10:40pm.
Autoactivation by Inactivity
With this function programmed, the alarm center will be activated as soon as the
time set for the zones to remain closed is achieved. The time must be entered with
two digits from 00 to 99 minutes. If 00 is entered, the Autoactivation by Inactivity
will be cancelled.
To program this function, type:
+
460 Inactivity time
+
Enter
Enter
+
00 to 99 minutes
To edit/view the programmed value, type:
460
+
Enter Enter
+
After changing the congured value, press the
Enter
key. If you only want to view
the setting, press the
Exit
key and no programming will be changed.
Programmed Autoactivation and Autodisactivation
These functions allow you to activate and deactivate the system automatically at
pre-programmed times, one for each weekday and one more special for holidays.
To use the function, follow the procedure:
1. Select the days of the week on which Autoactivation will occur;
2. Select the days of the week for Autodeactivation;
To Next Page
Loading...
