Intelbras AMT 8000 - Page 93

93
3. Schedule the desired times;
4. Adjust the system date and time;
5. Adjust the day of the week;
6. If you want to enable automatic time and date synchronization with the server
(make sure you are using the latest version of Intelbras IP Receiver for the correct
effect).
Use the table below for the following required settings:
Key Weekday
Key 1 Sunday
Key 2 Monday
Key 3 Tuesday
Key 4 Wednesday
Key 5 Thursday
Key 6 Friday
Key 7 Saturday
Key 8 Holiday
Selecting Autoactivation and Autodeactivation by Partitions
Selects which partitions will have the autoactivation and autodeactivation function
programmed. Factory default, all partitions enabled.
To program this function, type:
+
464
Group of partitions
+
Enter
Enter
0 = partition from 01 to 10
1 = partition from 11 to 16
+
Use the keyboard to enable the function on the partitions, partitions 01 through 10
are in partition group 0 and partitions 11 through 16 are in partition group 1, so
that the corresponding numbers for the partitions you want to have the function
enabled remain marked on the display and then conrm with the Enter key. If you
only want to view the setting, press the Back or Exit key and no programming will
be changed.
Note: if all partitions are selected, autoactivation will only occur if all zones of the
center are closed.
Days of the week for autoactivation
Select the days on which Partition Autoactivation will occur.