96
When the system date is the same as one of the programmed dates, the settings
of the weekday will be superimposed by the times programmed in the address of
the commands described above, referring to the programming of autoactivation of
the alarm center.
For the correct operation of this function it is necessary to check whether the
following programmed autoactivation and autodeactivation schedules are enabled
correctly:
» Days for programmed autoactivation.
» Time for programmed autoactivation.
» Days for programmed autodeactivation.
» Time for programmed autodeactivation.
» Weekday adjustment
» Time interval for date and time synchronization.
Set holidays for Autodeactivation/Autodeactivation.
If the center is partitioned, holidays can be dened per partition.
To program this function type:
404
+
Enter
+
Partition
Holiday No.
Day
Month
Enter
+ + + +
01 to 16
0 to 9
Note: »
in the above command for non-partitioned alarm center, use
Partition =
01
.
»
To disable a holiday, program the date with the value 00 for Day and
Month.
»
To edit/view the programmed value, type:
404
+
Enter
+
Partition
Holiday No.
Enter
+ +
01 to 16
0 to 9
To Next Page
Loading...
