98
Low System Battery/Restore System Battery 302
System Reset 305
Programming change 306
Absent Battery/Restoration Battery 311
Phone line Cut/Restore Phone line 351
Failure to communicate event 354
Failure of supervision/Restoration supervision 147
Expander Device Tamper/Restore Expander Device Tamper 145
Sensor Tamper / Restore Sensor Tamper 383
Low Battery of Wireless Device/Restoration Device Battery 384
System Activation/Deactivation 401
Automatic Activation/Deactivation 403
Remote Activation/Deactivation 407
Activation by a key 408
Remote access 410
Incorrect password 461
Zone Bypass/Restoration Zone Bypass 570
Periodic Test 602
Manual testing 601
Maintenance request 616
Event Buffer Reset 621
Restart date and time 625
Note:
some event codes may not be registered in allmonitoring software. If
necessary, register the corresponding comment, because these events facilitate the
identication and solution of problems.
When any event occurs, the alarm center will inform to the IP Receiver software the
device in the user/zone eld, according to the following table:
Device type Index/address initial Index/address nal
Sensor/zone 001 064
Remote control activation/
deactivation
100 197
Keyboard activation/deactivation 200 297
Keyboard failures 201 216
Siren failures 301 316
Amplier failures 401 404
The following are examples of sending
Contact-ID
events to the devices:
» Sensor trip in zone 01: event
130
(factory standard) and with user/zone being
001
.
» Sensor trip in zone 25: event
130
(factory standard) and with user/zone being
025
.
To Next Page
Loading...
