Intelbras AMT 8000 - Page 99

99
» Sensor communication failure in zone 12: event 147 (factory standard) and
with user/zone being 012 .
» Sensor reset in zone 64: event 130 (factory standard) and with user/zone being 064 .
» Sensor tamper in zone 05: event 383 (factory standard) and with user/zone
being 005 .
» Keyboard tamper registered at address 01: event 145 (factory standard)
and with user/zone being 201 .
» Siren tamper registered at address 09: event 145 (factory standard) and
with user/zone being 309 .
» Keyboard communication failure registered at address 01: event 381
(factory standard) and with user/zone being 201 .
As can be seen in the following commands, according to the registered Contact-ID
code, the event may be blocked if congured as 000 (will not be sent to the IP
Receiver). The registration of the Contact-ID code can be done according to the
available options of Contact-ID code, or even, when registering FFF will cause the
option that is registered with this value to send to the monitoring company the
default Contact-ID code.
The following tables show the events and the respective standard Contact-ID
codes:
Events of the opening type
Zone triggering
Zone no. Event Contact-ID Code
01 to 64 Zone triggering 130
The commands relating to the Contact-ID, more specically the Programmable
Contact-ID, the communication protocol must be set to Programmable Contact-
ID, otherwise events will be sent with the standard Contact-ID. Refer to the topic
Reporting mode, in the part explaining the Phone Protocol 1/2.
Use the table above to perform the Contact-ID event change command for zone
triggering described below:
901
+
Enter Enter
+ +
Zone N°
01 to 64