Setting Antenna Parameters
SETUP MODE ?
4
YES NO
1. Press the LEFT key to move cursor to YES and press the OK key to enter setup mode.
4
+ANTENNA +SATELLITE
+SYSTEM +INSTALLATION
2. Press the OK key to enter ANTENNA menu.
+MANUAL SEARCH + SET POL ANGLE
+SEARCH PARAM
4
+SET PARAMETERS
3. Press the RIGHT arrow key to move cursor to SET PRAMETERS menu and press the OK
key to enter SET PARAMETERS menu.
ENTER PASSWORD
- - - -
4. Access to the password protected system. Setup parameters is only required after
installation or repairs of your antenna system. These parameters should only be changed
by an authorized service technician. Improper setting of these parameters will cause your
system to perform improperly.
Press 4-digit password to enter SET PRAMETERS menu. (1590).
DETECT L EV EL TRACKING LEVEL
060 030
5. Set the DETECT LEVEL. (Range : 1-200)
The detect level is to set the satellite signal detection level.
Press the LEFT and RIGHT arrow keys until the desired character is underscored
(selected). Press the UP and DOWN arrow keys to increase and decrease the
selected character. Or press the NUMBER keys to set the desired value directly.
Press the OK key to set the new DETECT LEVEL.