Intellian v240C - Page 70

v240C – Marine Satellite Communication System
70
8. Press OK key to upgrade rmware.
Refer to the error messages below if any errors occur.
UPGRADE FIRMWARE
- FIRMWARE FILE NOT FOUND: the system cannot nd the FWP le.
- INVALID FIRMWARE: the le is not in a recognizable FWP format.
- MORE THAN 1 FILE EXIST: there is more than 1 rmware le that exists from the speci
ed folder in the USB ash drive.
- CHECK USB CONNECTION: the USB ash drive is not connected.
COPY LOG DATA
- COPY LOG DATA TO USB [30%]: display the copy progress in percentages.
- NOT ENOUGH SPACE IN USB: USB occupies no memory space.
- CHECK USB CONNECTION: the USB ash drive is not connected.
9. Press RIGHT arrow key to display the real-time diagnostic result.
The real-time diagnostic code will be displayed automatically if there is any error found
during the system operation. However, this page will not be displayed if there is no error
message.
Real-time
diagnostic
result
Upgrade
the
system
[DIAGNOSTIC] SENSOR BOX
CODE109 RESULTS : FAILED FN
UPGRADE ?
YES NO
ERASE DIAGNOSTIC ERROR LOG ?
YES NO
Erase
Error message
10. Press FUNCTION key to erase diagnostic error message.