Intellitronix BG6003 - Odometer, Performance Data, and Clock; Setting Odometer and Recording Data; Clock Adjustment

9 – BG6003 (rev. 02/19/2020) www.intellitronix.com
Setting the Odometer
While scrolling through ‘CAL’ mode you will see ‘ODO’ appear. This will allow you to enter the
vehicle’s actual mileage. Press the trip button again at this point and you will enter the odometer
set up mode. Press quickly to change the number of the digit on the right. Press and hold to advance
to the next digit. Do this for all 5 digits.
For Example: To enter the mileage 23456 into the odometer, at the ‘ODO’ prompt, tap the small
black button (quickly) two times, until the number 2 is displayed. Then press and hold the button
until the numbers 20 are displayed. Tap the button 3 times until 23 is displayed. Press and hold the
button until 230 is displayed and continue in this manner until 23456 is displayed. The speedometer
will advance to the home screen, five seconds after the last number is entered.
Recording and Viewing Performance Data
Follow these steps to record and recall Performance Data (high speed, ¼mile ET, and 0- 60 time):
1. Before each run, your car must be at a complete stop at the starting position. Press and hold the
push-button as it cycles through the performance data. At the end, the odometer will reset
ding.
2. Press the push-button until ‘HI-SP’ is displayed. The gauge will automatically cycle through the
performance data.
3. Start the run, pass, session, etc., as mentioned above.
4. When finished, repeat Step 2 to view the data gathered from the run. While stopped, you can
view this data as often as you wish. However, once it finishes scrolling one time, the memory is
ready to record new data and will begin recording again once the vehicle starts to move. The
highest speed measured over multiple runs will be retained in memory.
Clock Setting
Press the setting button under each section for hour and minute settings.