Intenso MB1 - Declara琀椀On of Conformity; Simpli昀椀Ed Declara琀椀On of Conformity

Risk of short circuit!
Do not insert any items, which are not intended for its use, into the openings of the
device. Do not operate the device with wet hands. This could result in injury from an
electrical short circuit and/or a re.
Do not use the device if there is visible damage to it or the USB cable, as this may
result in injury or damage.
Do not expose the device to splashing or dripping water.
Vessels lled with liquids (vases, glasses or similar) must not be placed on the device
or near it. There is a risk that the container will p over and the liquid will aect the
electrical safety.
It is normal that during the use the device produces heat. Do not completely cover
the product during use to avoid overheang.
Damage!
Keep the device away from any type of moisture and avoid dust, heat and direct
sunlight.
Do not use water or chemical soluons to clean the device. Only use a dry cloth for
this purpose.
Do not open the housing of the device and do not disassemble it into its component
parts. Do not try to repair it yourself. The guarantee expires in this case.
Avoid hard impacts to the device.
Operate the adapter only on earthed sockets with AC 100-240V~, 50/60 Hz. If the
power supply is not safe at the installaon site, ask the competent power supplier.
To interrupt the power supply of your device, disconnect the power supply from the
power socket. When disconnecng, always hold the adapter. Never pull the cable.
Declaraon of conformity
The CE marking says that this product meets the requirements of all EU
Direcves applicable for this product.
The UKCA marking says, that this product meets the requirements of all
UK Direcves applicable for this product.
Simplied declaraon of conformity
Intenso Internaonal hereby declares that the Wireless Charger MB1/MW1 complies
with Direcve 2014/53/EU. The full text of the EU Declaraon of Conformity is availa-
ble at the following internet address: www.intenso.eu.
EN - Page 3 of 5