Inter-m EP-9216 User Manual

5
EP-9216
EMERGENCY PANEL
Rear PanelRear Panel
1. DC 24V OUT TERMINAL
This terminal is used for connecting to the DC 24V IN terminal of an auto-broadcasting system.
2. MATRIX CONNECTOR
This multi-pin EMG jack is for the connection of an external timer, such as the Inter-M PX-9116.
3. PRE-AMP INPUT JACK
This jack is used to connect the output of a pre-amplifier.
4. REMOTE 1, 2 INPUT JACKS
These jacks are used to connect the output of a pre-amplifier to REMOTE 1 and REMOTE 2.
5. TIMER INPUT JACK
This jack is for the connection of an external timer, such as the Inter-M PW-9242N.
6. AUTO ANN INPUT JACK
Connect the output of an auto broadcasting system (or a cassette deck or other line level device) to this
balanced XLR input jack. This input is active when the AUTO ANN SELECTOR SWITCH (10) is set to external.
7. PRE OUT JACK
This balanced XLR jack carries the pre-amp out signal, and is used to make a mono connection to the main
amplifier and speakers.
8. REMOTE MIC TERMINAL
Connect an external microphone to this terminal. The external mic is active when the Remote Mic Switch (9) is
set to External.
DC OUT
24V
MATRIX
12 0
SIREN/VOLUME
PRE IN REMOTE IN 2 REMOTE IN 1 TIMER IN AUTO ANN IN PRE OUT
CONTROL OUT (TO AUTO ANN)
EXT INT
AUTO. ANN
REMOTE MIC
MIC SW
EXT INT
NO USER SERVICEABLE PARTS INSIDE.
RISQUE DE CHOC ELECTRIQUE NE
CTRIC SHOCK, DO NOT REMOVE COVER.
REFER SERVICING TO QUALIFIED SERVICE
CAUTION;
AVIS;
TO REDUCE THE RISK OF ELE-
PERSONNEL.
PAS OUVRIR.
S
N
12 34567
8 9 10 11

Inter-m EP-9216 Specifications

General

Brand	Inter-m
Model	EP-9216
Category	Security System
Language	English