Operating Instructions
4/8-indent crimping tool CO.236.00
Rev.: 2015-10-16 2 / 12
EN
Table of contents
1 General 3
2 Operation 4
3 Crimping procedure 5
4 Changing the locator 6
5 Changing the battery 6
6 Work process safety 7
7 Testing calibration to 2.0 mm using the gauge 7
8 Recalibrating the crimper (REC) 7
9 Calibrating your tool (CAL) after changing the battery 8
10 E1 message after calibration or recalibration 9
11 Wear monitoring – General 9
12 Troubleshooting and remedy 9
13 Servicing and maintenance 10
To Next Page
Loading...