Welcome
Congratulations on your purchase of the Inteset Systems 4-in-1 IR learning remote
control for Xbox and Windows Media Center. This infrared (IR) remote lets you
conveniently control your Xbox, Windows Media Center PC, and up to 3 other A/V
devices.
If you did not purchase an IR receiver from Inteset Systems or an R6 protocol
receiver is already installed, skip the sections in this manual that describe
installing the receiver.
INSERT THE BATTERIES
The remote control uses two AAA batteries that have been provided. Whenever
replacing batteries always make sure both are new.
To insert the batteries
Remove the battery compartment cover by
pushing on its release and lifting up.
Insert the batteries, making sure to properly
orient the positive (+) and negative (－) ends
as specified by the battery compartment
labels.
Replace the battery compartment cover.
POSITION THE RECEIVER
For optimum performance, make sure that the distance between the remote control
and the receiver doesn’t exceed 30 feet or about 60 degrees from the centerline of
the receiver. Keep a direct, unobstructed line
of sight between the receiver and the remote
control, and don’t let any natural or artificial
light shine directly on the receiver’s IR
sensor. If you already have an IR receiver,
and did not purchase the receiver from Inteset,
see Using the Remote Control later in this
User Manual.
To Next Page
Loading...