Interflex IF15x - Operation; Short-Time Release; Daily Release (Toggle Function)

9
 For operation, appropriate credentials are required (transponder card, key or key tag).
 The cylinder is delivered fully preassembled.
 On delivery, the knob module is in the factory state and must be programmed before
initial operation/installation. In this regard, see the Service Device instructions for use.
 All of the described proceedings always relate to a programmed knob module.
 In the version for Mifare transponders, the knob must be "woken up" by turning it on
before every step.
Short-Time Release
"Wake up" the knob module by turning it.
Hold the authorized credential in front of the knob module.
or
A visual-acoustic signal sequence indicates that the knob module is in release mode (
/
green)).
After approx. 5 seconds, the knob module switches back to idle mode, i.e. it can be turned
"empty" again.
See also
Visual/Audible Signals ................................................................................... 17
Daily Release (Toggle Function)
Please note: For this function, a credential with "Toggle Authorization" is required.
"Wake up" the knob module by turning it.
Hold the credential in front of the knob module until two visual-acoustic signal sequences
indicate that the locking cylinder is permanently released.
C
HAPTER
3
Operation