Interlogix ATS Series 500A - Page 3

P/N 466-2523 (ML) • REV D • ISS 16JUN17 3 / 42
6 Install
>Cancel<
Choose OK
Change PIN
Installer
Press Enter to continue
New PIN
>_
Enter the new installer PIN and press
Enter
Verify
>_
Next, enter the PIN again to verify it.
Change PIN
Supervisor
Press Enter to continue
New PIN
>_
Enter the new supervisor PIN and
press Enter
Verify
>_
Next, enter the PIN again to verify it.
The panel restarts.
Auto configuration
Auto Config?
>Yes<
Press Enter to continue.
Rkp 1-16 BUS1
R-?-------------
Exp 1-15 BUS1
-?-------------
Aud 1-16 BUS1
---?------------
Wait until the panel configures all bus
devices and zones.
Added
R:1 D:0 Z:8
A:0
Press Enter to continue.
Enabling service in
UTC F&S
THU 05 Mar 12:21
Enter the supervisor PIN and press
Menu
1>Zone options
2 Isolate
Go to menu 8.8 Service in
8>Service in
Enable?
Enable Installer in time
Press Cancel, Cancel to log off.
Programming menu entry
UTC F&S
THU 05 Mar 12:21
Enter the installer PIN and press Menu
Inh reports
>No<
Press Enter to continue
Inh tampers
Unset areas
1>Service menu
2 Device menu
The installer menu is displayed.
Changing encryption key
Caution: It is highly recommended to change the default
encryption key.
Go to 9.4.3 Encryption key 1 and 9.4.4 Encryption key 2.
3 Encrypt.key 1
>000000000000<
Provide encryption key 1.
4 Encrypt.key 2
>000000000000<
Provide encryption key 2.
Configuring zones
Go to 4.1 Zone menu.
4>Zones&Areas
Press Enter.
1>Zone menu
Press Enter.
0>Add zone
1 Zone 1
Select a zone.
For each zone used in the system, enter zone name in 4.1.n.1
Zone name.
01 Zone name
>1 Zone 1 <
Next, set its zone type in 4.1.n.2 Zone type.
02 Zone type
>Entry/Exit 1<
Adding users
Go to menu 3.1 Users.
0>Add user
1 Installer
Press Enter to add a user.
Add mode
>Manual<
Press Enter.
INFO
User added
01>User name
User 3
Press Enter.
01 User name
>User 3 <
Enter a new user name.
Configure other options of the user:
• 3.1.n.2 PIN
• 3.1.n.3 User card
• 3.1.n.6 User groups, etc.
Repeat for other users.
When leaving the user configuration, confirm locking the user
data.
Lock user data?
>Cancel<
Choose OK and confirm.
Configuring areas
Go to 4.2 Areas menu.