Chapter 3: System functions
46 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
4. Fire
Generates a fire alarm regardless of the status of the area.
Fire alarm causes pulsing siren sound. This alarm has higher priority than an
intrusion alarm.
Example: Smoke detector.
5. Panic
Generates a panic alarm regardless of the status of the area.
Example: panic button.
See also “8.8.1 Panic mode” on page 254.
6. 24H
Generates an intrusion alarm regardless of the status of the area.
7. Tamper
Generates a tamper alarm regardless of the status of the area.
Example: Panel tampers.
8. Exit terminator
This zone type is used to terminate an exit time. If the zone switches from active
to normal, the exit time is terminated and the area(s) are completely set as soon
as the final set delay has expired (see also “8.1.3.5 Final set delay” on page
235”).
9. Keyswitch
When the zone switches, the area is set / unset / part set depending on the zone
options selected.
Example: Key switch next to Front door.
See options “4.1.n.6.16 Key latch” on page 176, “4.1.n.6.17 Key set” on page
176, “4.1.n.6.18 Key unset” on page 177.
10. Medical
Generates a medical alarm regardless of the status of the area.
11. Technical
Generates a technical alarm regardless of the status of the area.
Example: temperature sensor.
See options “4.1.n.6.19 Technical full set” on page 177, “4.1.n.6.20 Technical
unset” on page 177.
12. Transmission path fault
Monitors the external reporting device.
To Next Page
Loading...
Need help?
General
